Clear Channel Corp AR-3500 Manual Page 6

SPLIT FREQUENCY OPERATION

Use Split Frequency Operation:

Turn SPLIT PRG off. Button should be out.
Turn SPLIT on. Button should be in and the SPLIT LED on the front panel will light.
Press + / - in if the transmit frequency will be higher than the receive frequency. The button should be out if the transmit frequency is lower than the receive frequency by the increment entered during the program procedure.

NOTE
The transceiver will not allow a transmit or receive frequency that is higher or lower than the upper limits of the frequency range.

Press the PTT button on the microphone to talk, release to receive. The transceiver displays the transmit frequency when the button is pressed and the TX LED on the front panel will light. When the button is released, the transceiver displays the receive frequency and the RX LED on the front panel will light.

NOTE
If you change the displayed frequency while using split frequency operation, the new frequency becomes your receive frequency. When you press the PTT button to transmit, the transceiver splits from the current frequency instead of the one you entered when you programmed split frequency operation.

To discontinue split operation, release the SPLIT button (out position). The SPLIT LED will go out.

Back To February 2002 Issue

^{Back
To February 2002 Issue}